Vello Freewave Manuel d'utilisateur Page 73

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 110
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 72
LUM0030AB Rev C
Chapter 5: Local Diagnostics Application
The Local Diagnostics application presents a real-time snapshot of MultiPoint setups that measure the
signal -to-noise level of the device. This information may be read from a Slave, Repeater, or Slave/Repeater
device. Use local diagnostic information to help direct a directional antenna of a Slave device by tracking the
signal and noise levels as the antenna is aimed back at the Repeater or Master.
Note: To run Local Diagnostics you must set the connected devices Diagnostics
parameter (located in the MultiPoint Parameters tab in the Configuration
application) to a value greater than zero.
Click Local Diagnostics in the Application pane to get started.
63
Vue de la page 72
1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 109 110

Commentaires sur ces manuels

Pas de commentaire